Software for sticks and modules based on the TI CC2652P1 chip
JetHome devices come pre-installed with software. The manufacturer does not recommend flashing their devices and only supports devices with factory pre-installed firmware or the firmware listed below in the Recommended Firmwares section.
When working with Zigbee2MQTT before flashing, read and follow the recommendations for migrating to a new stick or new software: Using Zigbee JetHome devices with Zigbee2MQTT
To work using the Zigbee protocol, it is recommended to use the following firmware:
- Zigbee coordinator firmware . The latest stable version is 20210218.
Important: Third party firmware may not be compatible or supported by JetHome devices. Therefore, JetHome devices are not guaranteed to work with third-party firmware.
JetHome modules and sticks based on the TI LAUNCHXL-CC1352P-2 reference design can also be equipped with software (firmware) supported by the CC2652P1 chip and designed to work on the TI LAUNCHXL-CC1352P-2 board:
- Zigbee coordinator firmware from the Zigbee2MQTT project In this firmware at the moment (version 20210708), one LED is implemented to indicate the joining mode.
- Zigbee router firmware from the Zigbee2MQTT project
Use firmware with file name: CC1352P2_CC2652P_launchpad_*