Warning Cookies are used on this site to provide the best user experience. If you continue, we assume that you agree to receive cookies from this site. OK

How to open the case of the JetHome JetHub H1 controller?

The body of the JetHome JetHub H1 controller consists of two parts: the lower part, in which the printed circuit board is fixed, and the cover. The parts of the case are fastened together using 8 latches inside the case. The lower part of the housing (view from the inside, the arrows indicate the location of the latches):

Housing cover (inside view):

To open the case, you can use a thin flat screwdriver or a special spatula. It is better to start opening the case from the latch located in the corner of the case:

Next, go to the latch on the edge of the case:

And so on, sequentially open all the latches around the perimeter of the case.