Warning Cookies are used on this site to provide the best user experience. If you continue, we assume that you agree to receive cookies from this site. OK

Home Assistant Operating System

For JetHome controllers, the Home Assistant Operating System (HassOS) operating system is available for testing: https://github.com/jethome-ru/homeassistant-operating-system

The Home Assistant operating system is based on a minimal build of Linux and uses Docker as the basis for deploying Home Assistant Supervisor as a container. Home Assistant Supervisor, in turn, uses Docker to manage Home Assistant Core and add-ons in separate containers. The Home Assistant operating system is not based on any Linux distribution, it is built using buildroot and is optimized to run Home Assistant.


  • Lightweight and efficient in terms of memory usage;
  • Minimum overhead on I/O operations;
  • Support for updates "over the air" (OTA);
  • Support for offline updates;
  • Modularity using Docker.

Official documentation: https://www.home-assistant.io/getting-started/

Initial launch

When you start the controller, after a few minutes, the Home Assistant web interface will be available at :8123 (where - address of this controller). Go to this address in a browser and follow the further step-by-step instructions.

Installing updates may take 10-15 minutes.

Download HassOS

Available HassOS builds for JetHome JetHub D1/H1 controllers:

Attention! HassOS builds starting February 25, 2021 cannot be flashed from USB Flash over builds prior to February 25, 2021 and over Armbian 5.7 builds. Flashing is possible only from AmLogic Burning Tool.

Flashing images with Amlogic Burning Tool

You can flash HassOS images using the Amlogic Burning Tool ( download the program )

See instructions for using the Amlogic Burning Tool program, as well as instructions for controller firmware:


Attention! When flashing HassOS images using the Amlogic Burning Tool, if the error “Uboot / Get result / DiskInital error” occurs, you must uncheck the “Erase flash” checkbox in the main program window: