Software for sticks and modules based on the TI CC2652P1 chip
JetHome devices come pre-installed with software. The manufacturer does not recommend flashing their devices and only supports devices with factory pre-installed firmware or firmware listed below in the Recommended Firmwares section. to a new stick or new software: Using Zigbee JetHome devices with Zigbee2MQTT
The following firmware is recommended for Zigbee protocol operation:
- Zigbee coordinator firmware. The latest stable version is 20210218.
Important: Third party firmware may not be compatible or supported by JetHome devices. Therefore, operation of JetHome devices with third-party firmware is not guaranteed.
For JetHome modules and sticks based on the reference design TI LAUNCHXL-CC1352P-2 software (firmware) supported by the CC2652P1 chip and designed to work on the TI LAUNCHXL-CC1352P-2 board can also be installed:
- Zigbee coordinator firmware from the Zigbee2MQTT project< /a> In this firmware at the moment (version 20210708), one LED is implemented to indicate the joining mode.
- Zigbee router firmware from Zigbee2MQTT project
Use named firmware File: CC1352P2_CC2652P_launchpad_*