JetHome JetHub E1 DIN Rail Controller
Please sign in so that we can notify you about a reply
- Processor module E1-CPU on the processor ESP32-D0WDQ6 with a frequency of up to 240 MHz;
- SPI flash 4MB;
- RAM 520KB.
Please read the documentation carefully before purchasing the device!
- During flashing, the controller can be powered from the MicroUSB connector located on the front panel of the controller. However, this power supply method is not intended for normal operation of the controller.
- DC controller supports Passive PoE
- The controller is supplied with software built on the basis of the ESPHome open project and designed to integrate the controller into the Home Assistant automation system or without software.
- You can install ESPHome, Arduino, PlatformIO or other software for ESP32 microcontrollers on the device.
- Documentation for installing Software and using controllers is available at docs.jethome.ru
- Example yaml configuration files for ESPHome are available in the repo.
- Cabinet dimensions: 130 x 76 x 57 mm.
- Case width 76mm, which is about 4 standard modules for a DIN rail (17.5mm);
- Weight: 250 g
- Ambient temperature: 0..+40 С;
- Relative air humidity up to 80% without moisture condensation;
- Closed explosion-proof rooms without aggressive vapors and gases.
- To use the device, you need to have basic knowledge of ESP32, Arduino/ESPHome/PlatformIO.
SPI NOR 4MB
AC 220v (terminal connector)
Платы и модули
No reviews found